MiniSuperPLCs RF Modules

Functions & Features:
The remote control module can be divided into SRCA AC type and SRCD DC type, which can perform the wireless control over MiniSuperPLC remotely and the control over the voice module and input/output. This function can be used in some special fields, such as, some poisonous and harmful fields where MiniSuperPLC cannot be control directly. Thus the MiniSuperPLC can be wirelessly controlled in the working room directly.
Remote input is to perform the control over the state of the input via the remoter, and actually the input points are expanded to perfom the wireless control over the voice module and the input. There are totally six input points and they are Y1, Y2, Y3, Y4, Y5, Y6. The remote receiving module can control the state of the MiniSuperPLC remote input points via the remoter within 70 meters.　　
The remote receiving module can be equipped with lengthened antenna (SEANT), which makes the signals received and transmitted even in some shielded fields.
The MiniSuperPLC wireless control makes your intelligent space unlimited. And your control will be freer and more 　convenient.

Technical Data: (Remote receiving module)

Technical Data: (Remote Transmitter)

Installation and Wiring:

1. Connection interface with PLC (to connect PLC, voice module)
2. Connection interface with PC communication and lower PLC
3. Remote receiving antenna
4. Power input of the remote module (AC or DC) (AC110V~220V) (DC 12V~24V)
5. Power indicator
6. STC remote transmitter

Usage of STC:
1. Strictly pair the transmitter and the receiving module. No mixed usage. The transmitter even cannot work with the receiving module of the same frequency cause they have different address code. They need to code with each other before outgoing.
2. The transmitter uses two units of “AA” battery.
3. When powering on or off, the START key on STC must be pressed before operation. After pressing START key, the indicators of Y1~Y6 will be green. At this time the transmitter send out the signal. If the indicators are red, this means the signals cannot be sent out and the remote receiving module cannot be controlled. Press STOP key, the transmitter stop sending. All the keys will be red only if the START key is pressed again.

Installation & Wiring:
Top hat rail DIN TS 35 or screw fixing 2 x M3 (diameter of pitch circle 4,0mm)

Wiring with the PLC:

Wiring between the remote module and PLC, voice module:

 Notes:

1. Power: AC type: AC 110V~240V, DC type: DC 12V~24V
2. The voice module can be connected with remote module to wireless control the voice module. Also the expansion module can be used in this system.
3. AC type PLCs must be connected with the voice module, expansion module and remote module of the AC type. And DC type PLCs must be connected with the voice module, expansion module and remote module of the DC type.
4. The remote module must be chosen in the system and programmed thus the operation on the remote module can be done.

SCM International, Inc.

English assistance by e-mail   Asistencia en español por e-mail

Mailing Address:
SCM International, Inc.
2648 E. Workman Ave. suite 527
West Covina, CA 91791 
USA

Fax: +1 (530)3256895

Corporate Headquarters POBOX:
SCM International, Inc.
POBOX 9793
Reno, NV . 89507
USA

(c) 2008, SCM International, Inc. All right reserved.