|
|
|
PLC Voice and Phone modules
   
Function & Features:
SVP can perform the record, broadcast and voice prompting function.
User can freely broadcast the needed sound and set the password
protection. Others cannot delete.
Dial the pre-set telephone number, When the demands are satisfied,
finishing the auto-dial, the auto notification and auto alarming
will be performed. Also the incoming signals by the telephone can be
remotely received to control the terminal equipment.
This module can directly record and can also record on PC by
recording software. On PC it can be recorded by SAUD. Also the
broadcast, voice message saving, recording and playing online,
password setting and message printing can all be done in the
software. Writing the voice message into the voice module can be
done with the communication cable.
Function & Features of SAUD:
Acoustics with strong interference rejection and lower signal
consumptions
The recording wire between the PC sound blaster and telephone voice
module
Plug and play, directly connected with PC
Technical Data:
|
|
|
|
|
|
|
|
|
|
Broadcast |
Totally 100 messages (Each message
is limited to 15 seconds and the total time is about 8
minutes.)
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Top hat rail Din
TS 35 or screw fixing 2XM3 (diameter of pitch circle 4.00mm)
|
Structure of the Voice Module
1— Connection interface between voice module and MiniSuperPLC
PLC
2— Connection interface between voice module and communication cable
3— MIC (the recording port when off-line recording or recording via
the PLC panel)
4— SPK (the internal speaker broadcast interface of the voice
module)
5— The frequency input port when recording online. (Connected with
the frequency output of the PC.)
6— Connection port of telephone crystal port (Connected with
telephone wire directly.)
7— Power and recording indicator of the voice module (When the voice
module is working, the indicator is green. When the voice module is
recording, the indicator is red. When recording, user must wait till
the indicator is light. And when the indicator is off, please stop
recording. Otherwise the message cannot be recorded.
8— Power (AC or DC) (AC 110~220V) (DC12V~24V)
9— Frequency output port of the voice module (Connected with the
wired sound box.
Installation & Wiring:
Installation Dimensions (mm): Top hat rail Din TS 35mm or screw
fixing 2XM3 (diameter of pitch circle 4.00mm)
Wiring of the Voice Module and
the PLC, PC
Wiring of the Voice Module and
MiniSuperPLC
series products
Notes:
1．Power input: AC type: AC 110V~220V, DC type: DC 12V~24V.
2. The voice module can bridge connected with remote module, to
wireless control the voice module. Also the expansion module can
be bridge connected in the system.
3. The PLC of AC type must be connected with the voice module,
expansion module and remote module of the same type. Also the
PLC of DC type must be connected with the voice module,
expansion module and remote module of the same type.
4. When programming, the related remote module must be selected to
the hardware configuration, thus the telephone voice module will
be able to be operated.
| |
 |
Code: SVPA
Only for: S12MRA and S22MRA |
|
| |
|
Code: SVPD
Only for: S12MRD and S22MRD |
|
| |
|
Code: SAUD
|
|
|
|
|
|
|
|
|
|
SCM International, Inc.
Mailing Address:
SCM International, Inc.
2648 E. Workman Ave. suite 527
West Covina, CA 91791
USA
Fax: +1 (530)3256895
Corporate Headquarters POBOX:
SCM International, Inc.
POBOX 9793
Reno, NV . 89507
USA
SCMStore.com, license and Conditions of use |
SCM International, Inc.
license the user to use this application by the term of a session, only under the
following terms and conditions:
|
(c)
2008, SCM International, Inc. All right reserved.
|
|
|
